Illuminated LED Push Button Switch - Customer Questions

How do I wire this so the light on the switch doesn't show up?

Just wire the red and black wires for the & - and ignore the brown wire as in this diagram: https://www.oznium.com/switches/led-power-switch#tech

How do i wire the LED to only light when pushed in and not light in the off position - by jeff

That is how the switch is already wired.

I was in the process of test fitting the switch and I dropped the locking nut and it cannot be found. Do you sell replacement nuts or do you know what I can use as a a replacement? thank you - by Shawn (Delaware)

Sorry, no replacement nuts. Not sure if a hardware store would have anything like that.

What size resister is needed to lower the illumination of the LED for nighttime use? Bill, PA.. - by William (Kunkletown, PA)

It depends on how much you want to lower it.
You can start by trying a resistor in the 400 to 600 ohm range though and see what happens.

If I was wiring this for multiple amplifiers in a car would I need ab additional relay to power them on? - by Daniel (United States)

Only if you want to run the amplifiers separate.

The diagram you provided is great but could you include one for how to wire this switch to keep the light on on the swith at all times? - by Bradley (Baytown Texas)

Instead of wiring NO and C together, simply wire C and + together.

How much load can I power through this switch. I am looking at a setup with 3 of the 10w spot/flood lights (the new ones) powered with a transformer, as well as some in cabinet lighting for my outdoor kitchen. Can it be compatibly wired with one of your transfer,ers? - by Nate (Texas)

Max is 15 amps. Can wire inline with our transformers. Each 10w Eclipse uses 900 mA so 3 of the lights woul use 2.7 amps.
AA

can I make the switch iluminated when off?

Yes, you can. The LED can be controlled independently (simply re-wire the switch).

you say this is water proof from the front.. does this mean if I mount it like in the pictures you show and seal that up I can submerse the button.

Yes

what if i can't ground it?

Then the switch won't light up.

What is the IP rating? - by Zsolt

IP65

Is it chrome or black? - by Zach (Oklahoma)

The face / bezel of the switch is silver.