Wireless RF Remote Wall Mount LED Dimmer Switch

It works with decent range and it resembles the Lutron wall plates although it's not as white as the Lutron ones. Putting them side by side will on a wall is a no-no.
Now to the installation issues. It does not fit in any standard electrical box, 120V or low voltage. There is no provision to be installed on drywall other than gluing it.
Taking the back cover off it is still impossible to fit it in an electrical box. The circuit board along with the ribbon for the front panel are too long to fit in an electric box.
Have you install one yourselves on a wall Oznium? If so how did u do it?
I ended up cutting an old work electrical box to take the securing "ears" that secure the box to the drywall and glue/screw them to the back of the dimmer so it resembles an old work electrical box. A lot of work to secure the dimmer on a wall.
Still cheaper than spending $100 for a Lutron ELV dimmer.

Really like this ... well thought out

Except, it will not wall install according to local building codes.

Does not fit in an electrical wall box ... plate will not seal over wall board

My RV had bathroom light and fan switches mounted at ceiling level and out of reach for my grandchildren. I mounted two of these switches on the wall and put the receivers in the ceiling near the light and fan. The installation was amazingly fast and easy and added a dimming/fan speed capability that I didn't have previously. The product works great, looks beautiful, is inexpensive and I couldn't be happier with it. As long as your device runs on 12 - 24 VDC and doesn't draw more than 8 amps this is an excellent solution.